Part Nos: LBS-XXX SAE 660 Bronze
(various sizes, per application)
Part Nos: LBS-CI-XXX A-48 Cast Iron
(various sizes, per application)

BHJ's Lifter Bore Sleeves are available in both SAE 660 Bronze and A-48 Cast Iron in a variety of sizes to suit standard Chevrolet, Ford and Chrysler I.D. applications. Standard Lifter Bore Sleeve (Lifter Bushing) sizes are nominal 1" O.D., by 1.500" long and are of a standard "Barrel Bushing" design.

All Sleeves are made-to-order and sized per the application. Press-fit O.D. sizes are dependent upon the size lifter being used, as well as the hole in the block into which the Sleeves will be installed. This hole-size must be specified when ordering to ensure proper press fit during installation. Longer Sleeve lengths are also available for applications with tall lifter bosses or other performance applications. Lengths of 1.600" through 2.00" are available for most I.D./O.D. combinations and must be specified when ordering. Shouldered, or other custom Sleeve design configurations can be accommodated on a special order basis.

Bronze Sleeves are also available in .937" I.D. for Jesel and other aftermarket lifter applications. Standard 1" O.D. as well as special 1.062" O.D. are also available for all I.D. sizes, though it is typically recommended that .937" Bushings use the 1.062" O.D. to maintain greater wall thickness. Cast iron Sleeves are available in longer lengths and special configurations mentioned above, but are not available in .937" I.D. or 1.062" O.D.

Quantity price breaks are available on all sizes at 25 (-2%), 50 (-5%), 100 (-10%) and 200+ units (-15%), per size.

BHJ's Lifter Bore Hone is also available to finish lifter bore I.D.s and attain proper clearance to the lifter after bushings are installed.